Delivered Gravel and Base Stone for Kihei
Kihei sits about 10 miles south of Kahului in Maui County. This page covers material choices for French drains, downspout outlets, low spots and swales, along with base stone for pads and drive areas. Hawaii Rock Supply lists bulk materials for projects that need proper grading, drainage paths and compacted support.
Material choices for Kihei projects
Start with the job under the finished surface. 3F Base Course, also called 3F or base course, is used under drive areas, equipment pads and other compacted sections. 3/4 Blue Rock is a clean stone suited to drainage zones, pipe bedding and areas where water needs open voids between the rock. Cinder provides a lightweight aggregate option for walkways and surface coverage.
For a compacted base, place material in manageable lifts and compact each lift before adding the next. A 4 to 6 inch base suits lighter flatwork and walkway support, while drive areas or weaker ground call for a deeper section based on the planned load and site conditions.
Ground, frost and drainage planning in Maui County
Hawaii's statewide frost-depth guide is 0 inches. Frost does not set the base depth here, but confirm project requirements with the local building department before construction, especially where a permit or engineered plan applies.
Water management drives the base and drainage plan. Windward and mauka lots may have heavy red clay that remains wet, while leeward ground may include volcanic soil or coral that drains quickly. Size drainage layers, swales and outlet paths around storm runoff, then keep water moving away from structures and finished surfaces.
For a low area, first establish where the water will travel after grading. A French drain uses a perforated pipe surrounded by clean rock, with a suitable outlet. Keep soil from mixing into the rock by using an appropriate separator fabric where the soil is fine or unstable.
Delivery planning for Kihei and nearby towns
Kihei is in Maui County, with ZIP code 96753. Kahului lies about 10 miles north of Kihei, and Wailuku lies about 14 miles northwest of Kihei. For project coordination, Kihei is also about 10 miles south of Kahului.
Before selecting a delivery date, mark the unloading point and check the full truck approach. Account for gate width, overhead clearance, turning room, soft ground and any area where a truck would need to back. Keep parked vehicles, tools and loose materials out of the drop zone. If the material needs to land on a driveway, protect the surface as needed and confirm that the placement area is ready before the truck arrives.
Measure the job before ordering
Use the material calculator to enter the project length, width and depth, then select the product that fits the work. Order online with a delivery date after the access route and unloading area are prepared.
